Dear All,
Scenario: Through Interface we push mass serial numbers from non SAP to SAP with pairing data
Condition: No same serial number push from non SAP to SAP System
Suppose X is material having 1234 serial numbers with ABCD pairing data
Issue: For X material 1234 Serial numbers are manually created by IQ04 ( not through interface) so this created serial number is without ABCD Pairing data
During confirmation there is one check which checks pairing data available or not, so during 131 movement we come to know there is no pairing for 1234 serial number
So we make deletion flag for 1234 SR No. of X material for push the same material X & same SR. No. 1234 with ABCD Pairing data from non SAP to SAP
But According to condition No same serial number push from non SAP to SAP System
So First through IQ02, for Sr.No: 1234 remove deletion flag & make it AVLB
Now Change Sr.No. 1234 to 9999 & now above condition is excluded & able to push same SR.NO 1234 for material X with ABCD Pairing data
Here we are getting correct serial number 1234 in AVLB Status with pairing data ABCD ( Interface Data just Pushed )
Again make deletion flag for SR No: 9999
But For material X having other serial numbers 1231, 1232 etc... showing last serial number as 9999 in IQ02 so how to delete this last serial number from system
If not change/delete there is any effect for in between serial numbers or for any reporting?? because same serial is updated in MASE table
As 9999 is last serial number showing in system is there any effect on other in between serial numbers which is pushed in SAP through non SAP system
Please help
Thanks & Regards,
Madhukar Poul